Pump Installation, install as close to the product tank as possible. And should be lower than the level of liquid or lower The rest In order to have the maximum suction power to transmit the pressure for suction and release positions of that pipe system Should connect directly with the joints and to the minimum.
The pump should be set so that it can access the pump and drive parts.This is for the benefit of inspection and repair. And there should be free space in front and behind the pump for the sake of disassembling the pump
Extreme temperatures can occur both inside the pump and around the pump. Depending on the liquid that is in the pump for work in temperatures exceeding 700° there should be preventive measures. And should provide warnings about the dangers of touching the pump
Preparing the base to support the pump Should be strong, horizontal, smooth and able to prevent vibration or swinging to prevent the movement of the base
To prevent errors in connecting electricity to the motor connecting an electric motor to a fire source should use a technician who has expertise in installing and connecting electricity to the motor
When viewed from the back of the motor the correct rotation direction of the motor must be clockwise. In case the pump rotates in the wrong direction will reduce the efficiency of the hydraulic system
Pipeline system (liquid delivery from the pump) should not use pipes that are smaller than the pump joints. And in the case of liquid that is viscous, it will increase the loss of power aside from the viscosity of the liquid other components of piping systems such as valves, elbows, filters, etc. can contribute to the loss of the pump power.
Pump inlet system the liquid to be pumped into the pump should be positioned higher than the pump. And the pipes should be angled to the pump also, be careful not to create bubbles. If a filter is installed at the pump inlet there should be a check of power loss at the pump inlet. Also, must check the pressure at the pump inlet to have enough power.
